Toshiba BU1207MG Manual page 21

6.2 Electronic shutter specification
Exposure time
MANUAL
Exposure time Accuracy
6.3 Random Trigger Shutter specification
Trigger Mode
External trigger
Software trigger
Exposure time
Edge mode
Level mode
Bulk mode
Number of Exposures in Bulk mode
Sequential Shutter
Trigger Delay
AntiGlitch
AntiChattering
6.4 GPIO Input signal specification
I/O Connector Pin No,
Input circuit
Input level
Polarity
Pulse width
Input impedance
Copyright © 2018 TOSHIBA TELI CORPORATION, All Rights Reserved.
External trigger, Software trigger (factory setting : External trigger)
Input via I/O connector
USB3 Vision command control
Edge mode, Level mode (factory setting : Edge mode)
The exposure time depends on the MANUAL Exposure time setting
The exposure time depends on External trigger width
The exposure time depends on the MANUAL Exposure time setting
255 times (maximum)
16 entries (maximum)
0 to 2000000μs (factory setting : 0μs)
90ns to 2ms (factory setting : 90ns)
2us to 2ms (factory setting : 2us)
DC3.3V
10kΩ
Low: 0 to 0.5V, High: 2.0 to 24.0V
High active / Low active (factory setting : Low active)
20
MANUAL
30μs to 16s
0.3μs
4 Pin : Line0
Inside
4
3
50μs (minimum)
High impedance
http://www.toshiba-teli.co.jp/en/
0V
D4278997A