Sealey MS080.V2 Instructions

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. Safety
do Not locate this tidy in such a position as to create the risk of injury from contact with the head or any other part of the body.
8
do Not overload this tidy; it should only be used for the designed purpose.
8
do Not locate in a position where items could fall from the tidy owing to accidental contact.
8
Ensure that the tidy is firmly fixed to the wall using either the masonry fixings supplied or alternative hollow wall fixings (not supplied).
9
ensure that, when installed, it can be accessed without over-reaching or over-balancing.
9
2. iNtroductioN
Powder coated steel construction, for added corrosion resistance. Wall mounting unit designed to organise the storage of gloves, clothing and
helmet.
3. iNStallatioN & aSSembly
3.1. Attach the wall plates to the two shelves using the four bolts provided. fig .2. ensure the wall plates are perpendicular to the shelves.
3.2. Hold the assembled shelves in the desired position and mark the wall through the four holes. fig.1
3.3. remove from wall.
3.4. Use proprietory wall fixings that are suitable for the type of wall and the weight of the loaded tidy. (not supplied)
3.5. Drill four holes suitable for the proprietory wall fixings.
3.6. Fix the shelves to the wall.
© Jack sealey limited
instructions for
motorcycle helmet & gear tidy
mS080.V2
model no:
Original Language Version
fig.1
ms080.V2 | issue 1 14/02/17