Other products from ASSA ABLOY Entrance Systems ............. Declaration of conformity ........................ All rights in and to this material are the sole property of ASSA ABLOY Entrance Systems AB. Copying, scanning, alterations or modifications are expressly forbidden without the prior written consent of the applicable company within ASSA ABLOY Entrance Systems AB.
Page 3
Instructions for safe operation Failure to observe the information in this manual may result in personal injury or damage to equipment. To reduce the risk of injury to persons - use this oper- ator with single or double pedestrian swinging or folding doors only.
Your local ASSA ABLOY Entrance Systems-authorized representative is familiar with these standards, as well as all applicable local codes and ASSA ABLOY Entrance Systems recommendations for power- operated pedestrian doors. Service and adjustments performed by your ASSA ABLOY Entrance Sys- tems-authorized representative, will ensure safe and proper operation of your automatic door unit.
ASSA ABLOY Entrance Systems-authorized resellers shall extend this warranty to end-users only, but have no authority to extend a greater or different warranty on behalf of ASSA ABLOY Entrance Systems. A service agreement with ASSA ABLOY Entrance Systems will help secure the availability of a fully operational system and will give priority at call-out, thus minimizing the time that the equipment is unusable.
The Besam SW200i can be set in three or four different modes, depending on optional programme selector type, see table below. In fully manual use (or in case of a power failure) the Besam SW200i acts as a normal door closer. Position Function The door is closed.
Surface applied application in 152 mm wide x 152 mm high header 152X152: Besam SW200i -OHC: OHC application in 152 mm wide x 152 mm high header Technical specification Manufacturer: ASSA ABLOY Entrance Systems AB Address: Lodjursgatan 10, SE-261 44 Landskrona, Sweden Type: Besam SW200i Mains power supply:...
The door must not hit you when opening nor when closing. If you are unsure of which type of sensor you have, please contact your ASSA ABLOY Entrance Systems representative.
Page 9
CLEANING The best way to remove dust and dirt from the Besam SW200i is to use water and a soft cloth or a sponge. A gentle detergent may be used. To maintain the quality of the enamel layer, the surfaces should be cleaned once/four months period.
Page 10
Recommended, if applicable (applied to both sides of the door) Activation by disabled people: Recommended, if applicable No entry, identifying one-way traffic: Mandatory in GB and US, if applicable Contact your ASSA ABLOY Entrance Systems service representative. For contact information, see last page. Issue 2013-12-18 1009729-EI-2.0...
Door stop (not illustrated) Safety accessories Even though the Besam SW200i is installed to comply with all applicable safety regulations, it is possible to enhance safety/comfort with the following add-ons (please contact your local ASSA ABLOY Entrance Systems company for detailed description).
Service/Maintenance As mentioned earlier in this manual, service and adjustments performed by your ASSA ABLOY Entrance Systems-authorized representative will ensure safe and proper operation of your automatic door unit. Remember to keep “Service Log Book” and “Site Acceptance Test and Risk Assessment” documents (PRA-0007) available.
Declaration of conformity ASSA ABLOY, the global leader in door opening solutions ASSA ABLOY Entrance Systems AB Lodjursgatan 10 SE-261 44 Landskrona Sweden declare under our sole responsibility that the type of equipment: Besam SW200i complies with the following directives:...
Need help?
Do you have a question about the Besam SW200i and is the answer not in the manual?
Questions and answers