Important Safety Instructions; Batteries And Chargers - DeWalt DCL077 Instruction Manual

English
12V/20V Max* Compact Task Light
DCL077

IMPORTANT SAFETY INSTRUCTIONS


WARNING:
precautions should always be followed, including
the following:
a ) Read all the instructions before using
the light.
b ) To reduce the risk of injury, close supervision is
necessary when a light is used near children.
c ) To reduce the risk of electrical shock, do not put
light in water or other liquid. Do not place or store
light where it can fall or be pulled into a tub or sink.
d ) Only use attachments recommended or sold by
the manufacturer.
e ) Turn the light off when not in use.
f ) Do not operate any light after it malfunctions
or is dropped or damaged in any manner.
Return light to the nearest authorized service
facility for examination, repair, or electrical or
mechanical adjustment.
g ) Use only the charger supplied by the
manufacturer to recharge.
SAVE THESE INSTRUCTIONS
Specific Safety Rules for Lights

WARNING: Do not place the light in a position
which may cause anyone to intentionally or
unintentionally stare into the light. Serious eye
injury could result.

WARNING: Fire hazard. Do not operate light or
charger near flammable liquids or in gaseous or
explosive atmospheres. Internal sparks may ignite
fumes causing personal injury.
Additional Safety Rules for Lights

WARNING: To reduce the risk of fire, do not place
anything on top of the lens during or after operation
of the light.

CAUTION: Only use light on stable surface. Do not
raise above work space/personnel via lifting, hoisting,
mounting, or suspension.
• Risk of electric shock. Do not expose to rain.
Store indoors.
• Do not submerge light in any liquid.
This appliance is not intended for use by persons
•
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Before using battery and light, read all instructions
•
and cautionary markings on area light, charger and
battery pack.
2
When using the light, basic
• Store the light indoors when not in use. Keep out of
reach of children.
• Place the light away from any heat source.
• Do not disassemble light. Take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock,
electrocution or fire.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
OPM .................... oscillations per
minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current

BATTERIES AND CHARGERS

The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
procedures outlined. When ordering replacement battery
packs, be sure to include the catalog number and voltage.
READ ALL INSTRUCTIONS
Important Safety Instructions for All
Battery Packs

WARNING: Read all safety warnings,
instructions, and cautionary markings for the
battery pack, charger and product. Failure to
follow the warnings and instructions may result
in electric shock, fire and/or serious injury.
• Do not charge or use the battery pack in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery
pack from the charger may ignite the dust or fumes.
• When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... avoid staring at
light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
IPXX .................... IP symbol