Frontgate Holiday Series Assembly Instructions Manual

Jackson spruce tree

Hide thumbs Also See for Holiday Series:

Manual (5 pages)

page of 27

/ 27
Bookmarks

Quick Links

Download this manual

PLEASE READ INSTRUCTIONS BEFORE ASSEMBLYING YOUR TREE

Your 7.5' Jackson Spruce Tree should contain the following:

If any piece is missing please contact a Frontgate

Product Specialist

HOW TO ASSEMBLE AND SHAPE YOUR TREE:

1. BEFORE STARTING TO ASSEMBLE YOUR TREE, CHOOSE A LOCATION NEAR AN 110V ELECTRICAL WALL

OUTLET FOR THE PRELIT TREE.

2. REMOVE THE 3 TREE SECTIONS FROM THE CARTON.

3. THE SECTIONS OF THE TREE ARE MARKED A THROUGH C. "SECTION A" IS THE BOTTOM, "SECTION B" IS

THE MIDDLE AND "SECTION C" IS THE TOP.

4. PLACE THE TREE STAND ON A LEVEL SURFACE AND INSTALL THE BOTTOM END OF THE LOWER

"SECTION A" INTO THE STAND. HOLD THE SECTION IN A LEVEL POSITION AND TIGHTEN THE THREE

SCREWS IN THE STAND AGAINST THE TREE TRUNK SURFACE. MAKE SURE THE SCREWS ARE

TIGHTENED AS EVENLY AS POSSIBLE MAINTAINING A SNUG AND SECURE POSITION. (FIG 1~2)

F R O N T G A T E

Holiday Collection

JACKSON SPRUCE 7.5ft TREE

(142157 CLE and/or 142157 MUL)

ASSEMBLY INSTRUCTIONS

(3 SECTIONS WITH 2 EXTENSION CORDS)

1 Tree stand

3 Eyelet screws

1 Remote control with single outlet 1 Power Strip/Surge Protector

FIGURE 1

Accessory kit

3 Tree sections labeled A, B, C

FIGURE 2

Need help?

Do you have a question about the Holiday Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Frontgate Holiday Series

Page 1 PLEASE READ INSTRUCTIONS BEFORE ASSEMBLYING YOUR TREE Your 7.5’ Jackson Spruce Tree should contain the following: 1 Tree stand Accessory kit If any piece is missing please contact a Frontgate 3 Eyelet screws 3 Tree sections labeled A, B, C Product Specialist...
Page 2 5. INSERT THE MIDDLE (“SECTION B”) INTO THE LOWER (“SECTION A”) TREE POLE. FINISH BY INSERTING THE TOP (“SECTION C”) INTO THE MIDDLE (“SECTION B”) TREE POLE. . (FIG 3~4) FIGURE 3 FIGURE 4 6. LOCATE THE DOUBLE PIGGY-BACKED PLUG FROM SECTION C AND PLUG INTO THE RECEPTACLE BOX LOCATED IN SECTION A.
Page 3 7.5’ JACKSON SPRUCE TREE:...
Page 5 BULBS AND FUSES: Fuses: The fuses are designed to prevent a short circuit or overheating that could lead to damage to the lights. The most common cause for a blown fuse is a power surge. Each cord string of Christmas tree lights has a fuse housed in the plug. When a fuse blows, the lights will simply stop working.
Page 6 To Replace Bulbs: 1. Unplug the Christmas lights. *****Make sure the light string is unplugged from the wall and any other light strings before you start working on it. 2. Remove each of the blown-out Christmas light bulbs. Use your thumb and index finger to delicately put pressure on each of the broken light's plastic jacket, to remove the bulb(s) from the bulb base.
Page 7: Remote Control Instructions
REMOTE CONTROL INSTRUCTIONS: THE REMOTE CONTROL INCLUDED WITH THIS TREE CONSISTS OF A TRANSMITTER AND A RECEIVER (PICTURED BELOW): **** THE SINGLE OUTLET RECIEVER IS TO BE PLUGGED INTO A GROUNDED ELECTRICAL OUTLET. **** (If you do not know or are unsure as to whether the intended outlet is grounded or not, please contact an electrician immediately to test and upgrade the outlet if needed.) PLUG THE POWER STRIP INTO THE RECEIVER’S OUTLET.
Page 8 TO OPERATE THE REMOTE CONTROL, SIMPLY PRESS THE BUTTON TO TURN ON THE LIGHTS AND THE BUTTON TO TURN OFF THE LIGHTS. TO REPLACE REMOTE CONTROL BATTERY: BATTERY SPECS: 12 VOLT, A23 SLIDE OPEN THE BATTERY COMPARTMENT DOOR ON THE BACK OF THE REMOTE TRANSMITTER REMOVE THE 12 VOLT, TYPE A23 BATTERY AND REPLACE WITH A NEW BATTERY.
Page 9 DO NOT STORE THE TREE IN A DAMP AREA OR IN AN AREA WHERE THE TEMPERATURE EXCEEDS 100˚ F. PLEASE CONTACT ONE OF OUR PRODUCT SPECIALISTS FOR ASSEMBLY ASSISTANCE OR QUESTIONS AT 1-800-537-8484 OR EMAIL PS@FRONTGATE.COM. SPECIALISTS ARE AVAILABLE WEEK DAYS 8:00 AM TO 8:00 PM OR SATURDAY 9:30 AM TO 6:00 PM.
Page 10 PLEASE READ INSTRUCTIONS BEFORE ASSEMBLYING YOUR TREE Your 9’ Jackson Spruce Tree should contain the following: 1 Tree stand Accessory kit If any piece is missing please contact a Frontgate 3 Eyelet screws 4 Tree sections labeled A, B, C, D Product Specialist...
Page 11 5. INSERT THE LOWER MIDDLE (“SECTION B”) INTO THE BOTTOM (“SECTION A”) TREE POLE. FOLLOW BY INSERTING THE UPPER MIDDLE (“SECTION C”) INTO THE LOWER MIDDLE (“SECTION B”) TREE POLE. FINISH BY INSERTING THE TOP (“SECTION D”) INTO THE UPPER MIDDLE (“SECTION C”) TREE POLE. . (FIG 3~5) FIGURE 3 FIGURE 4...
Page 12 9’ JACKSON SPRUCE TREE:...
Page 14 BULBS AND FUSES: Fuses: The fuses are designed to prevent a short circuit or overheating that could lead to damage to the lights. The most common cause for a blown fuse is a power surge. Each cord string of Christmas tree lights has a fuse housed in the plug. When a fuse blows, the lights will simply stop working.
Page 15 To Replace Bulbs: 1. Unplug the Christmas lights. *****Make sure the light string is unplugged from the wall and any other light strings before you start working on it. 2. Remove each of the blown-out Christmas light bulbs. Use your thumb and index finger to delicately put pressure on each of the broken light's plastic jacket, to remove the bulb(s) from the bulb base.
Page 16 THE REMOTE CONTROL INCLUDED WITH THIS TREE CONSISTS OF A TRANSMITTER AND A RECEIVER (PICTURED BELOW): **** THE SINGLE OUTLET RECIEVER IS TO BE PLUGGED INTO A GROUNDED ELECTRICAL OUTLET. **** (If you do not know or are unsure as to whether the intended outlet is grounded or not, please contact an electrician immediately to test and upgrade the outlet if needed.) PLUG THE POWER STRIP INTO THE RECEIVER’S OUTLET.
Page 17 TO OPERATE THE REMOTE CONTROL, SIMPLY PRESS THE BUTTON TO TURN ON THE LIGHTS AND THE BUTTON TO TURN OFF THE LIGHTS. TO REPLACE REMOTE CONTROL BATTERY: BATTERY SPECS: 12 VOLT, A23 SLIDE OPEN THE BATTERY COMPARTMENT DOOR ON THE BACK OF THE REMOTE TRANSMITTER REMOVE THE 12 VOLT, TYPE A23 BATTERY AND REPLACE WITH A NEW BATTERY.
Page 18 DO NOT STORE THE TREE IN A DAMP AREA OR IN AN AREA WHERE THE TEMPERATURE EXCEEDS 100˚ F. PLEASE CONTACT ONE OF OUR PRODUCT SPECIALISTS FOR ASSEMBLY ASSISTANCE OR QUESTIONS AT 1-800-537-8484 OR EMAIL PS@FRONTGATE.COM. SPECIALISTS ARE AVAILABLE WEEK DAYS 8:00 AM TO 8:00 PM OR SATURDAY 9:30 AM TO 6:00 PM.
Page 19 PLEASE READ INSTRUCTIONS BEFORE ASSEMBLYING YOUR TREE Your 10’ Jackson Spruce Tree should contain the following: 1 Tree stand Accessory kit If any piece is missing please contact a Frontgate 3 Eyelet screws 4 Tree sections labeled A, B, C, D Product Specialist...
Page 20 5. INSERT THE LOWER MIDDLE (“SECTION B”) INTO THE BOTTOM (“SECTION A”) TREE POLE. FOLLOW BY INSERTING THE UPPER MIDDLE (“SECTION C”) INTO THE LOWER MIDDLE (“SECTION B”) TREE POLE. FINISH BY INSERTING THE TOP (“SECTION D”) INTO THE UPPER MIDDLE (“SECTION C”) TREE POLE. . (FIG 3~5) FIGURE 3 FIGURE 4...
Page 21 10’ JACKSON SPRUCE TREE:...
Page 23 BULBS AND FUSES: Fuses: The fuses are designed to prevent a short circuit or overheating that could lead to damage to the lights. The most common cause for a blown fuse is a power surge. Each cord string of Christmas tree lights has a fuse housed in the plug. When a fuse blows, the lights will simply stop working.
Page 24 To Replace Bulbs: 1. Unplug the Christmas lights. *****Make sure the light string is unplugged from the wall and any other light strings before you start working on it. 2. Remove each of the blown-out Christmas light bulbs. Use your thumb and index finger to delicately put pressure on each of the broken light's plastic jacket, to remove the bulb(s) from the bulb base.
Page 25 THE REMOTE CONTROL INCLUDED WITH THIS TREE CONSISTS OF A TRANSMITTER AND A RECEIVER (PICTURED BELOW): **** THE SINGLE OUTLET RECIEVER IS TO BE PLUGGED INTO A GROUNDED ELECTRICAL OUTLET. **** (If you do not know or are unsure as to whether the intended outlet is grounded or not, please contact an electrician immediately to test and upgrade the outlet if needed.) PLUG THE POWER STRIP INTO THE RECEIVER’S OUTLET.
Page 26 TO OPERATE THE REMOTE CONTROL, SIMPLY PRESS THE BUTTON TO TURN ON THE LIGHTS AND THE BUTTON TO TURN OFF THE LIGHTS. TO REPLACE REMOTE CONTROL BATTERY: BATTERY SPECS: 12 VOLT, A23 SLIDE OPEN THE BATTERY COMPARTMENT DOOR ON THE BACK OF THE REMOTE TRANSMITTER REMOVE THE 12 VOLT, TYPE A23 BATTERY AND REPLACE WITH A NEW BATTERY.
Page 27 DO NOT STORE THE TREE IN A DAMP AREA OR IN AN AREA WHERE THE TEMPERATURE EXCEEDS 100˚ F. PLEASE CONTACT ONE OF OUR PRODUCT SPECIALISTS FOR ASSEMBLY ASSISTANCE OR QUESTIONS AT 1-800-537-8484 OR EMAIL PS@FRONTGATE.COM. SPECIALISTS ARE AVAILABLE WEEK DAYS 8:00 AM TO 8:00 PM OR SATURDAY 9:30 AM TO 6:00 PM.

This manual is also suitable for:

142157