Frontgate Holiday 142067 CLE Assembly Instructions Manual

ASSEMBLY INSTRUCTIONS
(3 SECTIONS WITH 2 EXTENSION CORDS)
PLEASE READ INSTRUCTIONS BEFORE ASSEMBLYING YOUR TREE
Your 7.5' Snowdrift Tree should contain the following:
If any piece is missing please contact a Frontgate
Product Specialist

HOW TO ASSEMBLE AND SHAPE YOUR TREE:

1. BEFORE STARTING TO ASSEMBLE YOUR TREE, CHOOSE A LOCATION NEAR AN 110V
ELECTRICAL WALL OUTLET FOR THE PRELIT TREE.
2. REMOVE THE 3 TREE SECTIONS FROM THE CARTON.
3. THE SECTIONS OF THE TREE ARE MARKED A, B & C. "SECTION A" IS THE BOTTOM,
"SECTION B" IS THE MIDDLE AND "SECTION C" IS THE TOP.
4. PLACE THE TREE STAND ON A LEVEL SURFACE.
5. INSTALL THE BOTTOM END OF THE LOWER "SECTION A" INTO THE STAND. HOLD THE
SECTION IN A LEVEL POSITION AND TIGHTEN THE FOUR SCREWS IN THE STAND
AGAINST THE TREE TRUNK SURFACE. MAKE SURE THE SCREWS ARE TIGHTENED AS
EVENLY AS POSSIBLE MAINTAINING A SNUG AND SECURE POSITION. (FIG 1~2)
F R O N T G A T E
Holiday Collection
SNOWDRIFT 7.5ft TREE
(142067 CLE)
1 Tree stand
3 Eyelet screws
1 Remote control with single outlet
1 Power Strip/Surge Protector
(Figure 1)
®
Accessory kit
3 Tree sections labeled A, B, C
(Figure 2)