Adjusting The Open And Close Limits Of The Sunsetter Awning - SunSetter Motorized Series Owner's Manual & Installation Instructions

ADJUSTING THE OPEN AND CLOSE STOP LIMITS
If a preset Open or Close stop position needs to be changed, but the Awning cannot stop automatically at
that position, possibly due to an obstruction such as a tree or shed being in the way, then see Appendix D on
Page 26 to clear the motor of preset stop positions and set new Open and Close stop positions.
CLOSE
my/STOP
OPEN
Channel
Indicator
Lights.
Channel Selector Button.
• Press to identify active Channel.
• Press while light blinks to
change Channel.
OPEN POSITION
When Open, the Lateral Arms are slightly bent
and the Fabric is snug.
The Fabric should be rolling over the top of the
Roller Bar (see Figure 23), not underneath (See
Figure 24). If the Fabric is rolling from the bottom
of the Roller Bar, continue unrolling the Fabric
until it rolls over the top of the Roller Bar. Then
roll up the Fabric until both the Lateral Arms
bend slightly and Fabric becomes tight.
CORRECT
Deck
Figure 23
APPENDIX A
FOR THE MOTORIZED AWNING
TO CHANGE THE OPEN LIMIT:
1. Select the correct Channel. The Remote was preset to operate on Channel 1.
2. Open the Awning to its current Open position and let it stop on its own.
3. Press and Hold the OPEN
Awning moves a little bit, or jogs back and forth, then release the buttons.
4. Adjust the Awning to the new Open limit position. The awning moves only
while pressing the OPEN
5. Press and Hold the "my"
back and forth, then release the "my"
6. Check the new Open limit.
TO CHANGE THE CLOSED LIMIT:
1. Close the awning to its current Closed position and let it stop on its own.
2. Press and Hold the OPEN
Awning moves a little bit, or jogs back and forth, then release the buttons.
3. Adjust the Awning to the new Closed position. The awning moves only while
pressing the OPEN
4. Press and Hold the "my"
back and forth, then release the "my"
5. Check the new Closed limit.
INCORRECT
Deck
Figure 24
and CLOSE buttons simultaneously until the
or CLOSE button.
button until the Awning moves a little bit, or jogs
button.
and CLOSE buttons simultaneously until the
or CLOSE button.
button until the Awning moves a little bit, or jogs
button.
CLOSE POSITION
The Awning should close to about 1" - 2"
between the Front Bar and the Arm Clamps.
See Figure 25.
Figure 25
Front
Bar
Area to
Watch
22
Arm Clamp