NEC Express5800 Series User Manual page 95

Chapter 2 Preparations
6. Connect the required internal and external cables to the PCI board. Refer to the documentation that came
with the PCI board.
7. Refer Chapter 2 (1.10 Riser Card) to install the Riser Card.
8. See Chapter 2 (1.5 Top Cover) to attach the top cover of the server.
9. Please see Chapter 2 (2 Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.
To connect a PCI card to the connector on motherboard with cable, connect a cable to PCI
Tips
card before installing Riser Card unit.
Note
Make sure that the edge of a PCI card bracket is seated into the fixed slot of the Riser
●
Card unit.
Depending on type of PCI cards, the terminal part of the PCI card may be too large to
●
fit in the connector.
If you have trouble installing the card, remove the card once and try again. If you
●
apply excessive pressure on the card, a PCI card or Riser Card might break.
In order to prevent damage of the system due to improper cooling or elevated temperature,
Note
please do not activate the server or enclosure without implementing any of component or
blank on all of drive bays and device bays.
Important
Re-attach the blank cover removed to maintain the internal cooling.
Express5800/R120h-2E User's Guide
1. Installing Internal Optional Devices
95