Yamaha 2007 V Star XVS650W Owner's Manual page 75

1. Wheel axle
2. Front wheel axle pinch bolt
3. Lift the front wheel off the ground
according to the procedure on
page 6-32.
4. Pull the wheel axle out, and then
remove the wheel.
CAUTION:
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
PERIODIC MAINTENANCE AND MINOR REPAIR
2. Lift the wheel up between the fork
legs.
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
ECA11070
1. Speedometer gear unit
2. Speedometer cable
3. Retainer
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
EAU24932
5. Tighten the wheel axle to the spec-
ified torque.
6. Tighten the front wheel axle pinch
7. While applying the front brake,
8. Connect the speedometer cable.
6-33
Tightening torque:
Wheel axle:
59 Nm (5.9 m·kgf, 43 ft·lbf)
bolt to the specified torque.
Tightening torque:
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
push down hard on the handlebars
several times to check if the front
fork compresses and rebounds
smoothly.
6