Indicator And Warning Lights - Yamaha 2007 V Star XVS650W Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Indicator and warning lights

3
1. High beam indicator light "
2. Turn signal indicator light "
3. Neutral indicator light "
4. Engine trouble warning light "
5. Immobilizer system indicator light (for
XVS650AW only)
Turn signal indicator light "
This indicator light flashes when the
turn signal switch is pushed to the left or
right.
Neutral indicator light "
This indicator light comes on when the
transmission is in the neutral position.
EAU11003
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.
Engine trouble warning light "
This warning light comes on or flashes
when an electrical circuit monitoring the
engine is defective. When this occurs,
have a Yamaha dealer check the self-
diagnosis system.
"
" The electrical circuit of the warning light
"
can be checked by turning the key to
"
"ON". If the warning light does not come
on for a few seconds, then go off, have
a Yamaha dealer check the electrical
circuit.
EAU11020
"
Immobilizer system indicator light
(XVS650AW)
The electrical circuit of the indicator
light can be checked by turning the key
EAU11060
"
to "ON".
If the indicator light does not come on
for a few seconds, then go off, have a
Yamaha dealer check the electrical cir-
cuit.
EAU11080 When the key is turned to "OFF" and 30
"
seconds have passed, the indicator
light will start flashing indicating the im-
mobilizer system is enabled. After 24
hours have passed, the indicator light
will stop flashing, however the immobi-
EAU11500
" lizer system is still enabled.
NOTE:
This model is also equipped with a self-
diagnosis device for the immobilizer
system. If the immobilizer system is de-
fective, the indicator light will start flash-
ing a pattern when the key is turned to
"ON". When this occurs, have a
Yamaha dealer check the self-diagno-
sis system. However, if the indicator
light slowly flashes five times, and then
quickly flashes two times repeatedly,
this error could be caused by signal in-
EAU38910
terference. If this occurs, try the follow-
ing.
1. Use the code re-registering key to
NOTE:
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
3-4
start the engine.