Replacing The Thermal Sensor - Lenovo S510 Hardware Maintenance Manual

3. Remove the front bezel. See "Replacing the front bezel" on page 82.
4. Locate the card reader. See "Computer components" on page 31.
5. Disconnect the card reader cable from the system board.
Note: Ensure that you note the location of the cable when you disconnect the cable from the system
board.
6. Remove the screw that secures the card reader. Then, pull the card reader out of the front of the chassis.
Figure 23. Removing the card reader
7. Install the new card reader into the chassis and align the screw hole in the with the corresponding
hole in the chassis.
Figure 24. Installing the card reader
8. Install the screw to secure the card reader to the chassis.
9. Reconnect the card reader cable to the card reader connector on the system board. See "Parts on the
system board" on page 34.
10. Install the front bezel. See "Replacing the front bezel" on page 82.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 113.

Replacing the thermal sensor

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the front audio and USB assembly, do the following:
.
Chapter 9 Installing or replacing hardware
91