Spray Prot Monitor - Toro 41106 Operator's Manual

Spray Pro Monitor
The Spray Pro monitor displays and monitors various
system performance data such as vehicle speed and
application rates. It does not control the application rate.
The monitor has an LCD screen that displays the data you
select, a selection dial, and 4 buttons for calibrating the
monitor (Fig. 25).
2
3 3
Figure 25
1. LCD screen
2. Selection dial
Selection Dial
The selection dial contains the following positions:
Speed
Displays the ground speed in miles per hour (if the
Units of Measure is set to US or TURF) or kilometers
per hour (if the Units of Measure is set to SI).
Units of Measure
Displays the current measurement unit selection as
follows:
– US (United States measuring system)
– SI (metric system)
– TURF (as US but the volumes are in US gallons per
1000 sq ft instead of US gallons per acre)
1
3 3
3. Calibration buttons
21
App. Rate
Displays the application rate in US gallons per acre
(US), liters pre hectare (SI), or US gallons per 1000 sq
ft (TURF).
Total Volume
Displays the total volume in US gallons (US and
TURF) or liters (SI) that you have applied since you last
pressed the [RESET] button for this setting.
Sub Volume
Displays the total volume in US gallons (US and
TURF) or liters (SI) that you have applied since you last
pressed the [RESET] button for this setting, without
affecting the Total Volume display. If you press
[RESET], the Sub Area also resets.
Distance
Displays the distance you have traveled in feet (US and
TURF) or meters (SI) since you last pressed the
[RESET] button for this setting.
Total area
Displays the total acres (US), hectares (SI), or sq feet
(TURF) that you have covered since you last pressed
the [RESET] button for this setting.
Sub Area
Displays the total acres (US), hectares (SI), or sq feet
(TURF) that you have covered since you last pressed
the [RESET] button for this setting, without affecting
the Total Area display. If you press [RESET], the Sub
Volume also resets.
Buttons
The monitor has the following buttons:
[RESET]
Resets the Total Volume, Sub Volume, Distance, Total
Area, and Sub Area display settings to 0.
[CAL]
Used to enter and exit the calibration mode.
[–]
Reduces values displayed on the screen during
calibration.
[+]
Increases values displayed on the screen during
calibration.