Washing The Machine; Cleaning And Storage - Toro 70185 Operator's Manual

5. Attach the hose coupling to the end of the mower
washout fitting and turn the water on high (Fig. 32).
Figure 32
1. Washout port
2. Coupling
Note: Spread petroleum jelly on the washout fitting o-ring
to make the coupling slide on easier and to protect the
o-ring.
6. Set the mower to the second height-of-cut (B) level.
7. Sit on the seat and start the engine.
8. Engage the blade (PTO) and let the mower run for 1 to
3 minutes.
9. Disengage the blade (PTO).
10. Stop the engine and wait for all moving parts to stop.
11. Remove the ignition key.
12. Turn off the water off and remove the coupling from the
washout fitting.
Note: If the mower is not clean after one washing, soak it
and let it stand for 30 minutes. Then repeat the process.
13. Run the mower again for 1 to 3 minutes to remove the
excess water.
1 2
3
m-3118
3. Hose
31
Warning
A broken or missing washout fitting could expose
you and others to thrown objects or blade contact.
Contact with the blade or thrown debris contact
may cause injury or death.
Replace broken or missing washout fitting
immediately, before using mower again.
Plug any holes in mower with bolts and
locknuts.
Never put your hands or feet under the mower
or through openings in the mower.

Washing the Machine

1. Stop the engine and wait for all moving parts to stop.
2. Remove the ignition key.
3. Wait 10 to 15 minutes for the engine to cool down.
4. Wash the machine with mild detergent and water.
Important Do not use a pressure washer to wash the
machine. Pressure washing may damage the electrical
system or wash away necessary grease at friction points.
Avoid excessive use of water, especially near the control
panel, lights, engine, and battery.
5. Start the engine to dry it off.

Cleaning and Storage

1. Disengage the blade (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean the dirt and chaff from the outside of the
engine cylinder head fins and blower housing.
Important
You can wash the machine with mild
detergent and water. Do not use a pressure washer to
wash the machine. Pressure washing may damage the
electrical system or wash away necessary grease at friction
points. Avoid excessive use of water, especially near the
control panel, lights, engine, and battery.
6. Check the parking brake; refer to Checking the Parking
Brake on page 27.
7. Service the air cleaner; refer to Servicing the Air
Cleaner on page 25.