Lenovo RackSwitch G8264 Installation Manual page 55

To remove a hot-swap power supply module, complete the following steps:
1. Remove the power cord from the power connector.
2. Press the release latch of the power supply module, and slide the module out of
the bay.
Release Latch
Attention: Do not leave the power-supply bay empty for more than 90 seconds
while the switch is operating. Either replace the power supply module or install a
blank power filler plate.
To return the component to customer service for replacement, see Appendix A,
"Getting Help and Technical Assistance" on page 75 to help you gather all the
required information that is necessary to return a component. After you remove the
component, securely pack the component for shipping.
55
© Copyright 2015 Lenovo Chapter 4: Removing and Replacing G8264 Components