Removing The Fan Module; Replacing The Fan Module - Lenovo RackSwitch G8264 Installation Manual

Removing the Fan Module

1.Loosen the retainer screw.
2.Grasp the extractor handle and gently pull the fan module from the slot.
Retainer Screw

Replacing the Fan Module

1.Select an empty fan module bay on the rear of the switch. If the target bay is covered by a blank fan
filler plate, loosen the retainer screw and slide the filler plate out of the slot.
2.Remove the new fan module from the antistatic shielded bag.
3.Slide the fan module into the card guides in the open slot and gently push it all the way into the slot, so
that it firmly engages with the connector (see the illustration). Each fan module has a mechanical guide
key to prevent you from inserting the module incorrectly.
© Copyright Lenovo 2017
To remove a hot‐swap fan module, complete the following steps:
Attention: If the inlet air temperature is above 35°C (95°F) while the switch is in
operation, replace the fan module within five minutes to avoid overheating the
switch.
To return the component to customer service for replacement, see Appendix A,
"Getting Help and Technical Assistance" on page
required information that is necessary to return a component. After you remove the
component, securely pack the component for shipping.
To replace a hot‐swap fan module, complete the following steps:
For example:
Retainer Screw
87 to help you gather all the
Chapter 4: Removing and Replacing G8264 Components
63