Installing A Qsfp+ Optical Transceiver - Lenovo RackSwitch G8264 Installation Manual

3.Pull up the locking lever to lock the transceiver into place.
4.Connect the fiber‐optic cable following the "Cabling Guidelines" on page

Installing a QSFP+ Optical Transceiver

Statement 3
54
G8264 Installation Guide
To remove an SFP+ optical transceiver, disconnect the fiber‐optic cable, and pull
down the locking lever to release the transceiver. After you remove the transceiver,
replace the safety cap.
The QSFP+ ports accept approved QSFP+ transceivers. The QSFP+ optical
transceiver provides an MTP cable connector for connecting to external ports.
CAUTION:
When laser products (such as CD‐ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
 Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable parts
inside the device.
Use of controls or adjustments or performance of procedures other than those

specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser diode.
Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil À Laser de Classe 1
36.