Installing The Battery; Removing The Hard Drive Assembly - Dell Latitude E5570 Owner's Manual

Installing the battery

NOTE: If your computer supports the 6-cell battery, it will not support a hard drive.
1. Connect the battery cable to the connector on the battery.
2. Route the battery cable through the routing channel on the battery.
NOTE: This step is applicable only for a 4-cell battery.
3. Insert the battery into the slot on the computer.
4. Tighten the screws to secure the battery to the computer.
5. Connect the battery cable to the connector on the system board.
6. Install the base cover.
7. Follow the procedure in

Removing the hard drive assembly

1. Follow the procedure in
2. Remove the:
a. base cover
b. battery
3. To remove the hard drive assembly:
a. Disconnect the hard drive cable from the connector on the system board [1] .
b. Remove the screws that secure the hard drive assembly to the computer [2].
c. Lift the hard drive assembly away from the computer [3].
After working inside your
Before working inside your
computer.
computer.
9