Table of Contents
Advertisement
3. Check good operation or not those parts after the
work.
CAUTION
Be careful not to be bite the wires by Cover Sensor,
when store the wires and the Scotch Lock in Cover
Sensor.
11.2. Disassembly of VC (Vegetable
Compartment)
11.2.1. PCB (VC)
1. Remove Crisper A'ssy
• Pull Crisper Case, take it out from each two portions
of Rail VC right and left.
-You can see the figure below (11.2.2.(1)).
2. Remove the screw that is fixation of Cover LED on
upper side of VC. Then remove Cover LED.
3. (3)Remove PCB (VC) while pressing left and right
hooks of reverse side of Cover LED.
4. (4)Pull the connector out while pressing the hook.
NOTES
• Be careful not to break PCB (VC) when it is removed and
installed.
11.2.2. CRISPER A'SSY
1. Remove Crisper A'ssy.
• Pull Crisper Case, take it out from each two portions
of Rail VC right and left.
11.2.3. DUCT VC
1. Remove Crisper A'ssy
• Pull Crisper Case, take it out from each two portions
of Rail VC right and left.
-You can see the figure (11.2.2.(1)).
2. Remove Duct VC A'ssy towards you while pulling the
hook of upper side.
3. Remove Duct VC.
• Remove the connector of Damper Thermostat, then
take Duct VC out.
• Take out INS Duct VCT and INS Duct VCB from four
hooks of Duct VC.
• Tear off Foam tape, removes Sensor SC from fixation
part of INS Duct VCT.
35
Advertisement
Table of Contents
