Table of Contents
Advertisement
NC2500S
Warning
Always connect to a ground prior
to connecting to the AC power supply.
• A very high, leaked current will flow
to the projector. Therefore, always
connect to a ground prior to connecting
to the AC power supply.
Connect the projector to exhaust
equipment.
• Use a duct, etc., to connect the projector's
air outlet to exhaust equipment that
can handle flow amounts of at least
3
16 m
/min. See section "Mounting Exhaust
Equipment " in this manual to mount
it correctly.
Equipment Installation and
Transport
• Be very careful not to allow the projector
head to be shocked or excessively
shaken when installing or transporting
the projector. The internal components
of the projector head can be damaged if
they are excessively shocked or shaken.
When opening the lamp door
• There is a high voltage lamp inside
the projector. There is the danger of
cracking the lamp, so never open this
door unless absolutely necessary. Also,
when opening the lamp door, use
the prescribed procedures to ensure
that you do it safely.
Installation
1. Place the projector on a flat, level
surface in a dry area away from dust
and moisture. Tilting the front of the
projector up or down from level
could reduce lamp life. Do not put the
projector on its side when the lamp
is on. Doing so may cause damage to
the projector.
2. Do not place the projector in direct
sunlight, near heaters or heat
radiating appliances.
3. Exposure to direct sunlight, smoke or
steam could harm internal components.
4. Handle your projector carefully.
Dropping or jarring your projector
could damage internal components.
5. To carry the projector, a minimum
of six persons are required.
Do not hold the lens part and the
anamorphic lens parts with your
hand. Otherwise the projector may
tumble or drop, causing personal
injury.
6. Do not place heavy objects on top
of the projector.
Power Supply
1. The projector is so designed that it
operates with the power supply voltage
described below.
• AC200-240V 50/60Hz
Ensure that your power supply fits
this requirement before attempting
to use your projector.
2. Consult your dealer for installing the
power cord to the projector. DO NOT
install the power cord by yourself. Doing so
may cause a fire or electric shock.
3. Handle the power cord carefully
and avoid excessive bending. Do
not place any heavy objects on the
power cord. A damaged cord can
cause electric shock or fire.
4. If the projector will not be used for
an extended period of time, shut
down AC power.
5. Placing the power cord and the
signal cable closely to each other can
cause beat noise. If this happens,
keep the two separated so that beat
noise is not generated. Beat noise is
corruption of the picture often seen as
a rolling band moving through the
image.
6. Do not touch the projector during a
thunder storm. Doing so can cause
electrical shock or fire.
Important Information
D-3
Advertisement
Table of Contents
