Configuration To Use Device Setup Tool - Fuji Xerox ApeosPort-VII C4421 User Manual

Configuration to Use Device Setup Tool

To create the job flow sheets using Device Setup Tool, the following settings are required.
TCP/IP address settings

 Enabling SOAP port
 Configuring SNMP port
 Installing Software
Reference

For information on how to set a TCP/IP address, refer to "Setting the IP address" (P.36).
 For information on the software installation, refer to "Overview of Job Flow Sheets" (P.196).
 Enabling SOAP Port
1
Log in to the System Administration mode.
Reference
 For more information, refer to "Login to Authentication Mode" (P.77).
2
Tap [Device] on the Home screen.
3
Tap [Connectivity & Network Setup] > [Port Settings] > [SOAP] > [Port Status].
4
Tap [Enabled].
5
Press the Home button.
Note
 Rebooting the device is required to enable the settings. Reboot the device following the message on the
screen.
 Configuring the SNMP Port
Configure the transport protocol for the SNMP port using CentreWare Internet Services.
1
Start CentreWare Internet Services.
Reference
 For more information, refer to "Starting CentreWare Internet Services" (P.85).
2
Log in to the System Administration mode.
3
Click [Network] on the left menu.
4
Click [SNMP], and then select the [Port] check box.
5
Select the [Authentication Failure Generic Traps] check box.
6
Click [Save].
Note

Rebooting the device is required to enable the settings. Reboot the device following the message on the
screen.
Configuration to Use Device Setup Tool
203