Module Connections; Motorized Valve; Standard I/O Or Analog + Relay; (Module Types 1, 2 And 7) - ABB C1900 Installation Manual

...4 ELECTRICAL INSTALLATION
4.2.9 Motorized Valve – Fig. 4.6
A motorized valve with or without feedback requires 2 relays
(common and normally open terminals) to drive the valve in
either direction. Any two relays can be allocated for this
function. Fig. 4.6 A shows two possible combinations.
Note. For valves with position feedback using
low voltage (mV), voltage (V) or current (C), refer
to Fig. 4.5 B, C and F for connections.
Four Relay Module
10 2
11 3
4
10 5
11 6
Type 1 and/or Type 2
Modules – see Note
Type 1 or Type 2
Module
4
5
6
Link – see Information
A – Standard Feedback Slidewire Configuration
Note. Type 1 and type 2 modules have one relay
output, therefore two modules are required.
8
(L)
Valve
Positioner
Power
Supply
(N)
100%
0%
Motorized
Valve Drive
0%
100%
Fig 4.6 Motorized Valve Connections (using feedback slidewire)

4.3 Module Connections

4.3.1 Standard I/O or Analog + Relay

(Module Types 1, 2 and 7) – Fig. 4.5
The connections are the same as Channel connections to the
main board. Refer to Section 4.2.
4.3.2 Four Relay Module (Module Type 3) – Fig. 4.7
1
2
3
4
L
5
N
6
7
8
9
10
11
12
Fig. 4.7 Four Relay Module Connections
Type 1 or Type 2
Module
4
5
6
Link – see Information
B – Alternative Feedback Slidewire Configuration
Information. Link must be connected at valve
drive end, not at the controller terminals.
Normally Closed
Normally Open
Common
Normally Closed
Normally Open
Common
Normally Closed
Normally Open
Common
Normally Closed
Normally Open
Common

(Module Type 3)

Motorized
Valve Drive
0%
100%
Relay 1
Relay 2
Relay 3
Relay 4