Epson PriorityFax 3000 Owner's Manual page 20

Rear
Front
To attach the output tray to the output tray base, locate the holes
on either side of the output tray base. Then insert the pegs on
either side of the output tray into these holes, as shown below.
This tray can be used in a horizontal position instead of
the vertical position shown on the next page. If you plan to
use the tray in the horizontal position, insert the pegs into
the rear slots instead of the front holes. Then push the
output tray as far back as it will go.
Setting Up the PriorityFax
1-7