Rear Gear Case Oil Check; Rear Gear Case Oil Change - CF MOTO UFORCE 1000 Owner's Manual

Maintenance

Rear Gear Case Oil Check

1� Place the vehicle on a level surface.
2� Remove the oil filler bolt (1) and check the oil level. The level should be up to the brim of the hole. If the
level is low, add sufficient oil to raise it to the specified level.
3� Install the oil filler bolt and tighten it to 18.4 ft-lb. (25 Nm).

Rear Gear Case Oil Change

1. Place vehicle on a level surface.
2. Place an oil pan under the gear case to collect the used oil.
3. Remove the oil drain bolt (2) at the bottom of the gear case and drain the oil.
4. Install the oil drain bolt and tighten it to 18.4 ft-lb. (25 Nm).
5. Fill with gear case oil by 13.5oz (400ml) into the filler hole (1).
6. Install the oil filler bolt and tighten it to 18.4 ft-lb. (25 Nm).
NOTE:
Approximate rear gear case oil capacity: 13.5 oz. (400mL)
1
2
1 Fill bolt 2 Drain plug
125