To Change The Engine Oil; To Change The Oil Filter - CF MOTO UFORCE 1000 Owner's Manual

To Change the Engine Oil

1� Start the engine and allow it to warm up for (2~3) minutes, then
stop the engine�
2� Place an oil pan under the engine to collect the used oil, and
then remove the dipstick�
3� Remove the engine oil drain bolt (1) to drain the oil from the
crankcase�

To Change the Oil Filter

1� Remove 3 engine oil bolts (1), open the filter cover (2) to take
out the filter.
2� Replace with the new oil filter(3).
Make sure the O-ring (4) is well and installed in the box.
3� Install the new oil filter (3) and fix the 3 bolts (1) in the oil filter
cover (2). Tighten it to specified torque.
Engine oil bolt (1) tightening torque: 7.3 ft-lb. (10 N·m)
Maintenance
NOTE
NOTE
119
1 Drain bolt, Engine oil
1
1 Engine oil bolt 2
1
2
Filter cover