Zero Point Calibration - Lippert Components Ground Control TT Installation And Owner's Manual

Zero Point Calibration

The "Zero Point" is the programmed point that the trailer
will return to each time the Auto Level feature is used. The
"Zero Point" must be programmed prior to using the Auto
Level feature to ensure the proper operation of the system.
The "Zero Point" feature is available on the OneControl
Touch Panel or the OneControl App.
NOTE: Images depicted are from the OneControl Touch
Panel.
1. Prior to starting this procedure, double check all
connections on the controller, jacks and touch panel.
2. When calibrating Zero Point, the user has full manual
control over the jacks. See Basic Jack Operation In Manual
Mode in the Operation - OneControl Touch Panel section
to adjust to the desired level position. Press the ENTER
button (Fig.35G) to set.
3. Press the gear icon (Fig.50A) for "options."
4. The screen will show "WARNING: ADVANCED
FEATURE" (Fig.50B).
B
Fig.50
5. Click "YES" to continue.
6. The screen will show "SET UP: Zero Mode Press
Enter" (Fig.51).
7. Press the ENTER button (Fig.51A).
lci1.com
A
574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)
A
Fig.51
8. The touch panel will present options for further leveling
of the trailer if needed. The screen will also state "ZERO
POINT CALIBRATION - Press Enter to Set" (Fig.52).
9. Press ENTER button (Fig.52A).
Fig.52
10. Screen will show "Zero point set!" (Fig.53).
Fig.53
33
CCD-0002700
TT
®
®
(3K-5K)
Rev: 03.02.21
A