Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
TO INSTALL THERMOSTAT
10. Seal hole for wires behind thermostat with non-
flammable insulation or putty, or use a wall
plate obtainable from a local hardware or home
building store.
11. Use supplied screws to mount thermostat base to
wall.
12. Insert stripped, labeled wires in matching wire
terminals by pressing on the corresponding
terminal contact. See the "Wiring Diagrams"
section of this manual.
NOTICE
Make sure exposed portion of wires do not touch
other wires.
13. Gently tug wire to be sure of proper connection.
Double check that each wire is connected to the
proper terminal.
14. Replace cover on thermostat by snapping it in
place.
15. Plug the unit in or turn on power to the system at
the main service panel.
16. Test thermostat operation as described in the
"Testing the Thermostat" section.
(cont.)
7
Advertisement
Table of Contents
