Electric Insert Fire Installation
•
The Electric heater is supplied with approximately 1.7 meters of flexible
mains cable. The appliance and surround should be located close to a
suitable mains socket and MUST be easily accessible to allow proper
connection.
•
This appliance MUST NOT be directly installed on a carpet or similar
material. We recommend that it is fitted onto a hearth or similar non-
combustible material.
•
This heater MUST be earthed. If in any doubt consult the manufacturer, its
service center or a qualified person.
•
The heater shall be installed into a location that has an opening with
minimum dimensions below:
•
Width: minimum 39 cm (15 1/2")
•
Height: minimum 55.5 cm (21 3/4")
•
Depth: minimum 11 cm (4 1/4")
•
Ensure the appliance is disconnected from supply socket.
•
Mark the center of the opening space of fireplace, measure 215.5mm to the
left and same to the right. Then measure from the floor 560mm up the wall.
This will be the location for the screw.
•
Once you have fitted the two screws in place (leave a 2mm gap), lift the fire
up to the hearth and fit the fire onto the two fixed screws.
7