2.5.
Sensor Node Installation
This section will guide you through the installation of the
station, and necessary electrical connections.
2.5.1.
Sensor Node Enclosure Installation
After a pole with the requirements mentioned in Section 2.3.1.2 is installed or located, the
Node enclosure can be mounted. The enclosure should be installed at a recommended height of
64 inches measured from the base of the pole to the top surface of the enclosure.
When the enclosure is raised to the specified height, insert the 2 inches U-bolts onto the
elongated holes of the enclosure as shown in Figure 13 and torque the U-bolts to 90 in-lbs. Ensure
that the backplate rests on the pole itself and not on the flange of the enclosure.
LUMEN TERRAIN User Manual
Figure 13: Node Enclosure Installation
Node enclosure, solar panel, weather
Sensor
Chapter 2. Installation
Sensor
25