Wiring Connection, Solar Panel - GE Baker Hughes LUMEN TERRAIN User Manual

Chapter 2. Installation
Remove Item 1 from Item 4. Items 2 and 3 should be already installed in the conduit but check to see if Item 3 is
secure by turning it clockwise. Remove the lock nut (Item 6) and insert Item 4 into knockout created previously
with Item 5 sitting on the outside of the solar panel junction box. Tighten Item 6 such that it grips to the interior
of the junction box and hand tighten Item 4. Use a wrench to tighten Item 4 by giving it 1 complete rotation.
Visually inspect Item 5 to ensure a watertight connection. Hand-tighten Item 1 into Item 4 followed by wrench
tightening Item 1 by turning it 1.5 turns.

2.4.5.1. Wiring Connection, Solar Panel

In the solar panel, remove the plastic bracket shown in the following figure and connect the wire
lugs of the conduit at the solar panel end to the terminals inside the junction box of the solar
panel as seen in Figure XXX, ensuring that the red wire (positive) plugs into the terminal
connected to the side of the diode with the gray strip. Place the plastic bracket back as seen in
Figure AAA
22
Figure AAA: Plastic Bracket in Solar Panel
LUMEN TERRAIN User Manual