Connecting To A Network; Network Cables; Connecting To Programmable Controllers, Personal Computers, Additional Hub Units, Or Bridges - Mitsubishi Electric NZ2EHG-T8N User Manual

4. Connecting to a Network

Network Cables

Cables meeting the following specifications should be used:
- 10BASE-T : Category 3 or higher UTP, STP cable 100m or less
- 100BASE-TX : Category 5 or higher UPT, STP cable 100m or less
- 1000BASE-T : Category 5e or higher UTP, STP cable 100m or less
- There are two types for UTP and STP cables: a straight-through cable and a crossover cable. The
Auto MDI/MDI-X feature allows connections using either type of a cable.
Connecting to Programmable Controllers,
Personal Computers, Additional HUB Units, or
Bridges
When connecting a programmable controller, personal computer, additional HUB unit, bridge, or other
device, connect it to any 10BASE-T/100BASE-TX/1000BASE-T port of the switching HUB unit using
either a straight-through or crossover cable.
CAUTION
To use Jumbo Frame, it is necessary for other network devices of the communication target, such as
LAN adapters, to be Jumbo Frame compatible.
NZ2EHG-T8N
Straight or cross cables
Figure 4.1. Connection example
Q06UDEHCPU .,etc
4. Connecting to a Network
20