Mitsubishi Electric NZ2EHG-T8N User Manual page 14

3. Setup of Hardware
(3) By lifting the unit, you can easily remove it from the DIN rail.
Figure 3.2. Removing a unit from a DIN rail with a phillips-head screwdriver < 3 / 3 >
For a flathead screwdriver
(1) Insert a flathead screwdriver (tooth width 5.5 to 7mm) into the latch metal fitting on the lower part
of the unit, and push the tip of the screwdriver down vertically.
Do not use excessive force. Doing so may damage the DIN rail mounting bracket or the unit.
Figure 3.3. Removing a unit from a DIN rail with a flathead screwdriver < 1 / 3 >
(2) The latch metal fitting is pushed down and the unit is ready to be removed from the DIN rail.
Figure 3.3. Removing a unit from a DIN rail with a flathead screwdriver < 2 / 3 >
13