Led Mode Select Button And Indicator Leds; Reset Buttons; Back Of The Switch - Aruba 4100i Series Installation And Getting Started Manual

LED
Green
Amber
Press the Mode Select button to switch between PoE mode or Spd Mode.

LED mode select button and indicator LEDs

The state of the switch port LEDs is controlled by the LED Mode select button. The current view mode is
indicated by the mode LEDs. To step from one view mode to the next, press the button to cycle through the
different modes.

Reset buttons

The Reset button is recessed from the front panel. (This design protects it from being pushed accidentally.)
The button is accessible through small holes on the top of the front panel. Use pointed objects, such as
unbent paper clips, to push it.
To Accomplish
this:
Soft reset Press and release the Reset button.
Hard reset Press and hold the Reset button for more
than 5 seconds, then release.

Back of the Switch

JL817A - Aruba 4100i 12-port 1GbE (8-port Class 4 POE and 4-port Class 6 POE) 2-port SFP+ DIN Mount
n
Switch
The rear panel of the switch has a latch for installation on a DIN rail. The latch is spring-loaded to move
down to position the switch over a DIN rail and return to the original position to secure the switch to a DIN
rail.
Description
Indicates DC input is within PoE operational range
Indicates DC input is out of PoE operational range
Do this: This will happen:
The switch operating system is shutdown
gracefully. The switch then reboots.
The switch reboots, similar to a power
cycle. A hard reset is used, for example,
when the switch CPU is in an unknown
state or not responding.
Introducing the Switches | 27