Toro Greensmaster Flex 21 Service Manual page 92

Factor
Stability of bedbar.
Number of reel blades.
Rear roller level.
Rear roller position.
Roller condition.
Traction speed.
Groomer reel operation.
Cutting Unit (Rev. C)
Possible Problem/Correction
Make sure bedbar pivot bolts are securely seated.
See Bedbar in Service and Repairs section.
Use correct number of blades for clip frequency and
optimum height–of–cut range.
Reel and rear roller should be parallel for proper
cutting performance.
See Leveling Rear Roller in Adjustments section.
The rear roller position is determined by the
height–of–cut.
See Rear Roller Height Adjustment in Adjustments
section.
Make sure rollers rotate freely. Repair bearings as
necessary.
See Roller Bearing Replacement in Service and
Repairs section.
Check maximum governed engine speed. Adjust
engine to specifications if necessary. The drive belts
may be loose or worn. Check the condition of the belts
and adjust or replace as necessary.
See Adjustments section in Chapter 3 – Engine and
Chapter 4 – Traction and Reel Drive System. Also, see
Service and Repairs section in Chapter 4.
See Troubleshooting section of Chapter 8 – Groomer
(Model 04201) or Chapter 9 – Groomer (Model 04204).
Page 7 – 8 Greensmaster Flex 21