Special Tools - Toro Greensmaster Flex 21 Service Manual

Special Tools

Order special tools from the TORO SPECIAL TOOLS
AND APPLICATIONS GUIDE (COMMERCIAL PROD-
UCTS).
Gauge Bar Assembly (13–8199)
Used to verify height–of–cut.
Backlapping Brush Assembly (TOR299100)
Used to apply lapping compound to cutting units while
keeping the operator's hands at a safe distance from the
rotating reel.
Bedknife Screw Tool (TOR510880)
This screwdriver–type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a 3/8" drive torque
wrench to secure the bedknife to the bedbar.
DO NOT use an air or manual impact wrench with this
tool.
Roller Bearing Installation Tools
Washers and spacer used to install bearings and seals
into front and rear rollers that have a threaded roller
shaft.
Seal installation washer (black): # 107–8133
Seal installation spacer: # 107–3505
Bearing installation washer (yellow): # 104–6126
Greensmaster Flex 21
Some tools may have been supplied with your mower or
available as TORO parts. Some tools may also be avail-
able from a local supplier.
Seal Installation
Washer
Page 7 – 5
Figure 5
Figure 6
Figure 7
Bearing Installation
Seal Installation
Washer
Spacer
Figure 8
Cutting Unit (Rev. C)