Installing The Bracket For Paint Robots - ABB FlexPendant Product Manual

2.2 Installing the bracket for paint robots

Introduction
The bracket holding the retractable cable unit should be installed in a location that
is suitable for your robot cell. ABB does not recommend installing it on the robot
controller cabinet.
The size and quality of the attachment screws depend on the installation place.
For information about the bracket for standard robots, see
for standard robots on page
The retractable cable unit must be installed vertically with the cable outlet at the
top and the connection cable to the controller pointing down, see figure.
xx1600000629
The retractable cable unit must be installed outside the paint booth.
The grounding cable must be connected.
Required equipment
Equipment
Retractable cable unit
Attachment screws and
washers
Product manual - FlexPendant Retractable Cable
3HAC048816-001 Revision: B
19.
Note
CAUTION
Note
2 pieces
The screw holes in the bracket has a diameter of 8 mm. ABB
recommends using M8 socket head cap screws and wide
flat washers. Screws and washers are not included in the
delivery.
© Copyright 2015-2016 ABB. All rights reserved.
2.2 Installing the bracket for paint robots
Installing the bracket
Continues on next page
2 Installation
21