Pro Fitness T3000 Assembly & User Instructions page 31

Care and Maintenance
Trouble Shooting
Error
Code
E00 Safety Key not in the position
No signal to Controller from
E01
console
E02 Motor communication error
E04 Incline Motor communication error
E05 Over current protector
E06 Motor Open Circuit
E08 IC Driver Error
E09 Folding up protect
E10 Motor instantaneous current
abnormal
E11 Over voltage protector
E13 No singnal to console from
Controller
E14 Lower voltage protector
29
1
Check
Re-locate the safety key in the correct position
A: Check the Main Controller Wire
B: Replace the PCB Board
A: Check the wire from motor to controller
B: IGBT breakdown, Replace the controller
C: Check the power voltage if 50% lower than rate
voltage
D: replace the motor wire or motor
A: Check the wire from incline motor to controller
B: Replace the incline motor
C: Replace the controller
A: Over loading or over resistance, restart the
treadmill
B: Transmission parts seized up, check the parts
C: Replace controller
D: Motor breakdown, replace the motor
Check the Motor wire
Replace the IC driver
A: Do not fold up the running deck when treadmill in is
running
B: If the running deck in laying position and show E09,
replace the controller
A: Adjust the torsion potentiometer of the Controller to
lower
B: Motor Breakdown, replace the motor
Voltage over 270v (for 220v) or 150v (for 110v) -- turn
off the treadmill and check the power source
A: Check the Main Controller Wire
B: Change the controller
Voltage lower than 160v (220v) or 70v (110v) -- turn off
the treadmill and check the power source
Solution