DeWalt D215821 Manual page 23

● Mount the appropriate accessory.
● Check the friction on the carriage.
● Mark the spot where the hole is to be drilled.
Unlocking the carriage (fig. K)
● To unlock the carriage (1) pull out the lock knob
(2).
● To lock the carriage move the carriage until the
locking shaft passes the hole (43) in the column
and jumps into place.
Always lock the carriage when the
@
assembly is not in use.
General tips for drilling with diamond core bits
Follow the core bit or manufacturer's
+
recommendations for using the
accessory.
Note: The use of a centredrill is not necessary.
● Take hold of the feed handle.
● Unlock the carriage.
● Switch on the drill motor in continuous mode.
● Slowly feed the accessory into the workpiece
using the feed handle.
● At the start of the cut, apply light pressure to
allow the accessory to perform the initial groove.
● Continue applying sufficient pressure to achieve
a smooth progressive cut. Do not force.
● Take extra care when the accessory is about to
break through the surface to prevent splintering.
● Always switch off the tool when work is finished
and before unplugging.
● After use move the carriage upwards until the
carriage locks into place.
Transporting
Always transport the stand with the
@
carriage locked.
Maintenance
Your attachment has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
Adjusting the carriage (fig. L)
After repeated use, the carriage may become
loose. To adjust the play, proceed as follows:
● Tighten the bolts (44) as necessary.
● Check the up and down movement of the
carriage.
Clearing the feed travel (fig. L)
The feed travel should be cleared periodically to
ensure smooth operation.
● Raise the carriage to the highest position
possible.
● Clear the gear rack (45) using a soft brush or
dry cloth.
A
Lubrication
Your attachment requires no additional lubrication.
Protecting the environment
Separate collection. This product must
Z
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to
you, do not dispose of it with household waste.
Make this product available for separate collection.
Separate collection of used products
z
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate
collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D WALT products once they have
E
reached the end of their working life. To take
advantage of this service please return your
product to any authorised repair agent who will
collect them on our behalf.
E N G L I S H
WALT product
E
23