Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Glow-worm Ultimate 3 Series
Summary of Contents for Glow-worm Ultimate 3 Series
- Page 1 The energy you need Operating instruc- tions Ultimate 3 GB, IE...
-
Page 2: Table Of Contents
Contents Contents Care and maintenance ....13 Maintenance ........ 13 Safety ..........3 Caring for the product ....13 Action-related warnings ....3 Checking the condensate drain Intended use ........3 pipework and tundish....13 General safety information..... 4 Decommissioning...... 13 Notes on the documentation .. -
Page 3: Safety
Safety 1 ral heating installations and for 1 Safety hot water generation. 1.1 Action-related warnings Intended use includes the fol- Classification of action-re- lowing: lated warnings – observance of the operating The action-related warnings instructions included for the are classified in accordance product and any other system with the severity of the pos- components... -
Page 4: General Safety Information
1 Safety ▶ Do not use any electrical 1.3 General safety switches, mains plugs, door- information bells, telephones or other 1.3.1 Installation by skilled communication systems in tradesmen only the building. The installation, inspection, ▶ If it is safe to do so, close the maintenance and repair of the emergency control valve or product, as well as the gas ratio... - Page 5 Safety 1 – The product itself flue gas may escape into the room air. – to the gas, air, water and electricity supplies ▶ In order to operate the – to the entire flue gas install- product, ensure that the con- ation densate siphon is always full.
-
Page 6: Notes On The Documentation
1 Safety lead to corrosion on the product 2 Notes on the and in the air/flue pipe. documentation ▶ Ensure that the supply of 2.1 Observing other applicable combustion air is always free documents of fluorine, chlorine, sulphur, ▶ You must observe all operating instruc- dust, etc. -
Page 7: Product Description 3
(1) and in the short operating 3.2 Benchmark instructions (2) (→ Page 7). Glow-worm is a licensed member of the 3.4 Information on the Benchmark Scheme. Benchmark places responsibilities on both identification plate manufacturers and installers. -
Page 8: Overview Of The Operator Control Elements
3 Product description 3.6 Description of the display Information Meaning on the identi- fication plate Type: Xx3(x) Approved flue gas connec- tions Maximum water pressure in heating mode Maximum water pressure in hot water handling mode V/Hz Electric connection Max. electrical power con- Operating in- Display showing sumption... -
Page 9: Timer
Operation 4 3.8 Timer 4.1.2 Starting up the product You can control the heating mode using the timer. Position for Functionality the selection switch Heating mode permanently switched off Heating mode intervals in ▶ Press the (2) button. accordance with the timer ◁... -
Page 10: Filling The Heating Installation
4 Operation 2. Slowly open the filling cock, as shown Note to you by the competent person. If the heating flow temperature 3. Fill with water until the required filling is shown in the display, press pressure is reached. and hold the buttons 4. -
Page 11: Setting The Heating Flow Temperature
Operation 4 ◁ The actual heating flow temperature 4.6.1 Switching the warm start is set automatically by the boiler. function on and off Applicability: Combination unit, Available warm 4.8 Product settings start function for hot water Note ▶ Hold the buttons down simultan- The sequence in which the avail- eously for more than 3 seconds. -
Page 12: Switching The Product To Standby Mode
5 Troubleshooting 4.10 Switching the product to 4.11.2 Frost protection for the standby mode system ▶ Press the button for less than three Note seconds. Ensure that the product's power ◁ and gas supply are working cor- Once the requirement currently in rectly. -
Page 13: Fault Codes In The Display
Care and maintenance 6 7 Decommissioning 5.2 Fault codes in the display Fault codes have priority over all other dis- 7.1 Temporarily decommissioning plays. If several faults occur at the same the product time, the corresponding codes are dis- ▶ Temporarily decommission the product played alternately for two seconds each. -
Page 14: Guarantee And Customer Service
9.2 Customer service For contact details for our customer ser- vice department, you can write to the ad- dress that is provided on the back page, or you can visit www.glow-worm.co.uk. Operating instructions Ultimate 3 0020239565_01... -
Page 15: Appendix
Appendix Appendix A Operator level – overview Setting level Values Unit Increment, select Default set- ting Min. Max. Heating installation Pressure in the heating in- Current value stallation ℃ Heating flow temperature Current value Preset in the system Hot water generation Hot water temperature Current value ℃... - Page 16 Appendix Fault Cause Measure Product does not There is air in the heating installation. Purging the radiators start up: If the problem occurs again: In- form the competent person – No hot water After three successive failed ignition Press the button.
- Page 20 Publisher/manufacturer Glow-worm Nottingham Road ‒ Belper ‒ Derbyshire DE56 1JT Telephone 01773 824639 ‒ Technical helpline 0330 100 7679 After sales service 0330 100 3142 www.glow-worm.co.uk 0020239565_01 0020239565_01 ‒ 15.07.2019 supplier © These instructions, or parts thereof, are protected by copyright and may be reproduced or distributed only with the manufacturer's written consent.
Need help?
Do you have a question about the Ultimate 3 Series and is the answer not in the manual?
Questions and answers
Can I just put my boiler on hot water only, as I have a choice on my remote for heating - hot water
Yes, the Glow-worm Ultimate 3 Series boiler can be set to hot water only. The manual indicates that the boiler has different operating modes, including a "Hot water only" mode.
This answer is automatically generated