Miele ProLine CS 1013-1 Operating And Installation Instructions page 46

Installation
Fitting the ProLine appliance
 Feed the mains connection cable
down through the worktop cut-out.
 Starting at the front, position the
ProLine appliance in the worktop cut-
out.
 Using both hands, press down evenly
on the sides of the ProLine appliance
until it clicks into position. When
doing this make sure that the seal
underneath the appliance sits flush
with the worktop on all sides. This is
important to ensure an effective seal
with the worktop.
Do not use any sealant (e.g. silicone)
on the ProLine appliance.
If the seal does not meet the worktop
correctly on the corners, the corner
radii (≤ R4) can be carefully scribed to
suit.
46
Fitting several ProLine appliances
 Push the built-in ProLine appliance to
the side until the holes in the spacer
bar can be seen.
 Fit the cover strip  into the
corresponding holes in the spacer bar
.
 Starting at the front, position the
ProLine appliance in the worktop cut-
out.
 Proceed as described previously.