Fingerprint Sensor Assembly - HP ProBook 445 G6 Maintenance And Service Manual

Fingerprint sensor assembly

Table 6-6 Fingerprint sensor assembly description and part number
Description
Fingerprint sensor assembly
Fingerprint sensor bracket (included in Bracket Kit)
Fingerprint sensor cable (included in the Cable Kit)
Fingerprint sensor insert (included in Plastics Kit; for use in models without a fingerprint sensor)
Before removing the fingerprint sensor assembly, follow these steps:
1. Prepare the computer for disassembly
2. Place the computer in "Battery Safe mode"
3. Remove the following components:
a. Bottom cover
b. Battery
c. Hard drive
Remove the fingerprint sensor assembly:
1. Disconnect the cable from the ZIF connector on the fingerprint sensor (1).
2. Slide the bracket toward the inside of the computer, and then lift it off the fingerprint sensor board (2).
TIP: A tool may be required to push and disengage the bracket.
(Bottom cover on page
(Battery on page 36).
(Hard drive on page 41)
(Preparation for disassembly on page
(Battery Safe mode on page
35).
Spare part number
L44516-001
L44586-001
L52216-001
L44551-001
34).
34).
Component replacement procedures 51