Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Wilko HG1605WK
Summary of Contents for Wilko HG1605WK
- Page 1 3 BURNER GAS BBQ Assembly instruction (0428601) 0359-17...
-
Page 2: Expanded View
Expanded View... -
Page 3: Parts Supplied
Parts Supplied Please check parts against the list below before assembling your Barbecue Grill. Take a few moments to familiarise yourself with the contents. Check that all holes are clear of paint before assembly, if you find a blockage, please use a screw driver to clear the blocked hole. Warming rack Grease cup Upper cart frame... -
Page 4: Fittings Supplied
Fittings Supplied Screw ST4.8x10 Nut M8 Screw M5x15 Lock washer Step screw M5x15 Washer Step screw M6x22 Screwdriver Screw M6x15 Wrench M8 Wing bolt M6x15 Screwdriver (included), wrench (included) and plastic head hammer (not included) are required to assemble the Barbecue. •... - Page 5 Assembly Please read all instructions thoroughly before proceeding. Find a large, clean area in which to assemble your barbecue. Please refer to parts list and assembly diagram as necessary. Assembly of the barbecue involves many large components, it is advisable to have two people assemble the unit. STEP 1: A: Attach upper cart frame (12) to lower left cart frame (13) ((A) Screw 2Pcs).
- Page 6 STEP 2: A: Attach upper cart frame (12) to lower right cart frame (18) ((A) Screw 2Pcs). Note: Use plastic head hammer slowly and gently to strike on the upper cart frame insert into lower right cart frame if needed. Make sure the upper cart frame and lower right cart frame must be faced to the correct orientation as shown in below diagrams.
- Page 7 STEP 3: A: Attach axle (19), wheel (17) to the assembled right cart frame ((G) Nut 2Pcs). (17) (19) (17) STEP 4: A: Attach upper front panel (15) to lower front panel (16) ((B) Screw 2Pcs). (15) (16)
- Page 8 STEP 5: A: Attach the assembled front panel to the assembled left and right cart frame. ((B) Screw 6 Pcs). Note: Make sure the left and right cart frame must be faced to the correct orientation as shown in below diagrams. STEP 6: A: Attach rear panel (14) to the assembled left and right cart frame ((B) Screw 4Pcs).
- Page 9 STEP 7: A: Attach lid handle (4) to lid & fire-bowl assembly (7) ((I) Washer 2Pcs / (H) Lock washer 2Pcs / (E) Screw 2Pcs). B: Attach control knob (8) onto valve stem. C: Attach temperature gauge (5) onto lid.
- Page 10 STEP 8: A: Attach lid & fire-bowl assembly onto the assembled cart frame ((E) Screw 5Pcs / (I) Washer 2Pcs). B: Attach lighting hook (9) onto the assembled cart frame ((F) Wing bolt 1Pc). C: Hang the lighting hook onto wing bolt (F).
- Page 11 STEP 9: A: Fix the side shelf (6) onto the screw hole of right cart frame by using the step screws ((C) Step screw 2Pcs). Note: Another two step screws were pre-assembled on the upper screw hole of right cart frame for hanging the side shelf (6) (See below picture a, b &...
- Page 12 STEP 11: A: Attach grease cup support (10) onto fire-bowl assembly. B: Place grease cup (11) onto grease cup support. (11) (10) STEP 12: A: Slide warming rack (1) into holes in lid and fire-bowl. Note: Look for corresponding holes on side of lid, insert short wire end into lid hole one side at a time. Position warming rack legs into slots on fire-bowl sides.
- Page 13 STEP 13: A: Fix the step screw D at the front panel of left side shelf ((D) Step screw 2Pcs). STEP 14: A: Place heat plate (3) onto heat plate support. B: Place cooking grid (2) into fire-bowl assembly.
-
Page 14: General Safety Warnings
General Safety Warnings Important: Read all the safety warnings and assembly instructions before use and retain all information for future reference. • Read assembly instruction enclosed & all the safety warning before using the appliance. Failure to follow instructions could result in death, serious body injury or property loss. •... -
Page 15: Installing Gas Cylinder
Installing Gas Cylinder To operate you will need (1) precision-filled gas cylinder between 11kg and 15kg. Your barbecue will perform better if propane gas cylinder is used. CAUTION: Gas cylinder must be properly disconnected and removed prior to moving this grill. Specification of Gas Cylinder*（*Gas cylinder not included）. - Page 16 Connect Gas Cylinder 1. Make sure control knobs are “OFF’’ position. 2. The regulator rubber hose and regulator are properly and securely connected. 3. The regulator handle is in the “OFF’’ position. (Figure C). 4. Remove the seal cap from the automatic valve on the gas cylinder. 5.
-
Page 17: Checking For Leaks
Checking for Leaks Burner Connections 1. Make sure the regulator valve and hose connections are securely fastened to the burner and the gas cylinder. Visually check the connection between the burner venture pipe and orifice. Make sure the burner venture pipes fit over the orifice. - Page 18 4. Connect gas cylinder per “Installing Gas Cylinder” section. 5. To turn regulator ON, turn the regulator valve counterclockwise to the “ON” position. (Figure D) Caution: If you are unable to turn the regulator handle to the “ON” position, your regulator is not properly connected. Do not force the handle to open.
-
Page 19: Cleaning And Care
5. With lid open or closed, cook until desired internal food temperatures are achieved. 6. Turn grill “OFF” per ‘’Turning off” instruction. For more tips on direct cooking please see “Tips for Better Cookouts and Longer Grill Life” Indirect Cooking CAUTION: Do not leave grill unattended while preheating, cooking or burning off food residue on “HIGH”. -
Page 20: Technical Specification
6. Place protective cap cover on gas cylinder and store tank outdoors in a well ventilated area out of the direct sunlight. 7. If storing the grill outdoors, cover the grill with a grill cover for protection from the weather. Technical Specification Model Number: HG1605WK Gas Category: I 3+(28-30/37) -
Page 21: Troubleshooting
Troubleshooting Produced in China for Wilko, Roebuck Way, Manton Wood, Worksop, Nottinghamshire, S80 3EG Careline 08000 329 329 www.wilko.com...
Need help?
Do you have a question about the HG1605WK and is the answer not in the manual?
Questions and answers