Dimensions; Mounting The Device Directly On A Flat Surface - National Instruments FD-11601 User Manual

Figure 35. Ambient Temperature Locations, Vertical Mounting Configuration
Measure the ambient
temperature here
Measure the ambient
temperature here
25.4 mm
(1.00 in.)

Dimensions

For detailed dimensional drawings and 3D models, visit
FD-11601.

Mounting the Device Directly on a Flat Surface

For environments with high shock and vibration, NI recommends mounting the FieldDAQ
device directly on a flat, rigid surface using the mounting holes on the device. This mounting
technique requires four M5 or 10-32 panhead or sockethead cap screws appropriate for the
surface.
Complete the following steps to mount the FieldDAQ device directly on a flat surface.
1. Prepare the surface for mounting the device using the surface mounting dimensions.
76.2 mm
(3.00 in.)
99.3 mm
(3.90 in.)
76.2 mm
(3.00 in.)
FieldDAQ
IN OUT
9-30 V
10 A TOTAL
99.3 mm
STATUS
0 1 (3.90 in.)
LINK/ACT
10/100/1000
SYNC
76.2 mm
(3.00 in.)
76.2 mm
(3.00 in.)
ni.com/dimensions
FD-11601 User Guide | © National Instruments | 45
Measure the ambient
temperature here
Measure the ambient
temperature here
25.4 mm
(1.00 in.)
and search for