Advertisement
Removing the power transformer
Prior to performing the following procedures, remove
the top cover.
1.
Disconnect the harness from the connector CN55
/CN56 and CN811 on the power trans1 board.
2.
Unsolder the seven solder parts on the power trans2
board.
3.
Remove the four screws U attaching the power
transformer.
Removing the voltage selector board
Prior to performing the following procedure, remove
the top cover.
1.
Removed the two screws G attaching the voltage
selector board to the rear panel (see fig.4).
2.
Unsolder the six solder parts on the voltage selector
board.
Removing the power/fuse board
Prior to performing the following procedure, remove
the top cover.
1.
Removed the two screws G attaching the voltage
selector board to the rear panel (see fig.4).
2.
Remove the screw H attaching the power/fuse board
to the rear panel (see fig.4).
3.
Remove the screw V attaching the power/fuse board.
4.
Unsolder the eight solder parts on the power/fuse
board.
Removing the power supply board
Prior to performing the following procedure, remove
the top cover and relay board.
1.
Cut off the tie band if needed.
2.
Disconnect the card wire from the connector CN402
on the power supply board.
3.
Disconnect
the
harness
CN55/CN56 on the power trans1 board (see fig.17).
4.
Remove the three screws W attaching the power
supply board and pull out the power supply board
removing the hook.
5.
Unsolder the three solder parts on the power supply
board.
(See Fig.17)
(See Fig.17)
(See Fig.17)
(See Fig.18)
from
the
connector
CN55/CN56
CN811
U
Solder part
Power cord
Solder part
(on the reverse side)
Fig.17
Headphone jack board
Power supply board
W
CN402
Solder part
(on the
reverse side)
Hook
RX-8022PSL
Power
supply board
Power
trans1 board
Power
transformer
Power
trans2 board
Voltage
selector board
Solder part
(on the reverse side)
Power/fuse board
V
Solder part
Headphone jack
W
Tie band
W
Tie band
Fig.18
1-7
Advertisement
