Advertisement
Disassembly method
Removing the top cover (See Fig.1)
1.
Remove the four screws A attaching the top cover
on both sides of the body.
2.
Remove the three screws B on the back of the body.
3.
Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
1.
Cut off the tie bands.
2.
Disconnect the harness from the connector CN416
(on the video audio board), CN206 (on the video
board) and CN244 (on the S video board) (see fig.8).
3.
Disconnect the card wire from the connector CN400
on the audio board and CN402 on the power supply
board.
4.
Remove the three screws C fixing the upper surface
of the front panel, and four screws D fixing the
bottom.
5.
Detach the front panel assembly toward the front.
6.
Remove the screw X attaching the earth wire (see fig.
19).
Removing the compulink board
Prior to performing the following procedure, remove
the top cover.
1.
Disconnect the harness from the connector CN393
on the compu link board.
2.
Remove the three screws E attaching the compu link
board to the rear panel.
Removing the rear panel
Prior to performing the following procedure, remove
the top cover.
1.
Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2.
Remove the thirty seven screws E & F & G & H
attaching the each board to the rear panel.
3.
Remove the three screws I attaching the rear panel
on the back of the body.
(See Fig.2 and 3)
(See Fig.2 and 4)
(See Fig.4)
Top cover
A
(both sides)
Fig.1
C
Main
board
Audio
board
CN400
Fig.2
D
Fig.3
F
F
F
Rear panel
I
I
Fig.4
RX-8022PSL
B
Front panel assembly
C
Power
supply board
CN402
Tie band
Compu
link board
CN393
Front panel assembly
Cord stopper
F
E
G
F
H
I
1-3
Advertisement
