Panasonic et-jpc100bu Installation Instructions Manual page 26

Installation (continued)
360°
3) Tighten the fi xing screws.
 While supporting the main unit, securely tighten the rotating fi xing screw and two ball joint fi xing screws
with the 7/64" Allen wrench supplied with the projector.
Attention
 The main unit and power supply section of the projector are connected by a cable, etc. Do not rotate and
change the tilt of the main unit more than necessary.
Attention
 The rotating fi xing screw and ball joint fi xing screws are hexagon socket head screws (M6). Take care because
they will come out of the projector if loosened too much.
 After making rough adjustments, refer to the operating instructions of the projector and then fi nely adjust the
projection position, focus, and projection screen size while actually projecting images. If necessary, also correct
any keystone distortion.
26 - ENGLISH
Ball joint movement range:
Approx. 90°
 When you loosen the two ball joint fi xing
screws, the ball joint can move freely.
This allows you to rotate the main unit 360° or
tilt the main unit 90° with the ball joint moving
part.