Table of Contents
Advertisement
Installation (continued)
Adjusting the projection position
This section describes determining the projection position by adjusting the orientation of the main unit of the pro-
jector.
Ball joint fi xing screws
Rotating fi xing screw
2) Adjust the orientation of the main unit.
Align the ball joint moving part to the angle at which you want the main unit to be tilted and then adjust the
orientation of the main unit.
Ball joint fi xing
screws
Rotating fi xing screw
Shaft holder
Main unit
Power supply unit
Main unit
Ball joint movable part
360°
1) Loosen the fi xing screw of the projector.
Loosen the rotating fi xing screw and the two
ball joint fi xing screws of the projector with the
7/64" Allen wrench supplied with the projector.
When you loosen the rotating fi xing screw, the
shaft holder can rotate 360°.
Turn the ball joint moving part to the angle at
which you want the main unit to be tilted.
ENGLISH - 25
Advertisement
Table of Contents
