Storage; Cleaning And Storage - Toro 74405FR Operator's Manual

Storage

Cleaning and Storage

1. Disengage the PTO, set the parking brake, stop
the engine, and remove the key.
2. Remove grass clippings, dirt, and grime from
the external parts of the entire machine,
especially the engine. Clean dirt and chaff from
the outside of the engine cylinder head fins
and blower housing.
Important: You can wash the machine
with mild detergent and water. Do
not pressure wash the machine. Avoid
excessive use of water, especially near the
control panel, engine, hydraulic pumps,
and motors.
3. Service the air cleaner; refer to Servicing the
Air Cleaner, Engine Maintenance, page 21.
4. Grease and oil the machine; refer to Greasing
and Lubrication, Lubrication, page 20.
5. Change the crankcase oil and filter; refer to
Engine Oil, Engine Maintenance, page 21.
6. Check the tire pressure; refer to Tire Pressure,
Drive System Maintenance, page 28.
7. Charge the battery; refer to Servicing the
Battery, Electrical System Maintenance,
page 25.
8. Check the condition of the blades; refer to
Cutting Blades, Mower Maintenance, page 29.
9. Prepare the machine for storage when non-use
occurs over 30 days. Prepare the machine for
storage as follows.
10. Add a petroleum based stabilizer/conditioner
to the fuel in the tank. Follow the mixing
instructions from the stabilizer manufacturer.
Do not use an alcohol based stabilizer (ethanol
or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and
used at all times.
A. Run the engine to distribute the conditioned
fuel through the fuel system (5 minutes).
B. Stop the engine, allow it to cool, and drain
the fuel tank; refer to Draining the Fuel
Tank, Fuel System Maintenance, page 24.
C. Restart the engine and run it until it stops.
D. Choke or prime the engine. Start and run
the engine until it will not start. Operate the
primer, if equipped, several times to ensure
no fuel remains in the primer system.
E. Dispose of fuel properly. Recycle as per
local codes.
Important: Do not store
stabilizer/conditioned gasoline
over 90 days.
11. Remove the spark plug(s) and check
its condition; refer to Spark Plug,
Electrical System Maintenance, page 25.
With the spark plug(s) removed from the
engine, pour two tablespoons of engine oil
into the spark plug hole. Use the starter to
crank the engine and distribute the oil inside
the cylinder. Install the spark plug(s). Do not
install the wire on the spark plug(s).
12. Clean any dirt and chaff from the top of the
mower.
13. Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash
the mower with a garden hose.
14. Check the condition of the drive and mower
belts.
15. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is worn or
damaged.
16. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service
Dealer.
17. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place. Cover
the machine to protect it and keep it clean.
36