Toro 30986 Operator's Manual page 23

Figure 22
1. Control rod fitting
2. Lower mounting holes
3. Rear frame
4. Lower flange bolt (3/8 x 1
inch)
5. Upper flange bolt (3/8 x
1-1/4 inches)
6. High position
5. Adjust the control rod length by rotating the control
rod in the rod fitting (Fig. 8).
6. Install hairpin cotter between drive levers and
neutral locks and into clevis pins (Fig. 25).
Note: Make sure the clevis pins are inserted into
the neutral locks.
7. Perform the hydraulic linkage adjustments when the
handle height is changed; refer Hydraulic Linkage
Adjustments.
7. Lower position
8. Upper mounting hole
9. Handle
10. Flange nut (3/8 inch)
11.
23