Switching Off The Unit; Unloading The Dishwasher; Delay Start - Kenwood KID60X16 Installation Instructions Manual

switching off the unit

To save energy, remember to switch the dishwasher off using the Power button. The dishwasher will
continue to use electricity until it is switched off.
If the dishwasher is not going to be used for a long period of time,
e.g. whilst on holiday, disconnect the unit from the mains supply.

unloading the dishwasher

Allowing dishes to cool down before unloading is important as dishes tend to break and chip more
easily when they are hot. Therefore, if you open the dishwasher door fully after switching off, it will
allow the dishes to cool down much faster.
• Unload the lower basket first, followed by the cutlery basket and then the
upper basket.
• This will prevent water drops from the upper basket from falling on to the
dishes in the lower basket.

delay start

The starting time of a wash programme can be delayed and adjusted. Please follow the steps
below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Press the Power button to turn on the dishwasher.
3. Select your preferred programme.
4. Press the Delay button.
5. Set the required delay start time using the delay button.
Each press of this button increases the delay start time by 1 hour increments.
6. Close the door and the unit will start the programme at the assigned time automatically.
31