Page 4
unloading the dishwasher ....................25 delay start.......................... 25 half load ..........................25 cleaning after use ......................26 external care ........................26 - the door and the door seal ..................26 - the control panel ...................... 26 internal care ........................26 - filtering system ......................
Thank you for purchasing your new Kenwood Dishwasher. These operating instructions will help you use it properly and safely. We recommend that you spend some time reading this installation/instruction manual in order that you fully understand all the operational features it offers.
Installation installation location When selecting a position for your dishwasher you should make sure the installation surface is flat and firm, and the room is well ventilated. Avoid locating your dishwasher near a heat source, e.g. cooker, boiler or radiator. Extreme cold ambient temperatures may also cause the appliance not to perform properly.
Page 7
installation 3. The height of the unit is 820 mm. The figure outlines the minimum dimensions required to accommodate the dishwasher within fitted kitchen furniture units. unit in mm 4. Do not connect the unit to the mains socket before installation. Ensure you are not installing the unit right in front of the mains socket.
Page 8
installation 7. Position the dishwasher next to a water tap and a drain. Ensure the water inlet and drain hoses are not kinked or squashed. The unit must not stand on the mains cable. 8. To secure the dishwasher under the table top, tighten the screws through the top sides of the unit onto the table top.
Page 9
installation 10. Install the Aesthetic Panel onto the dishwasher door. Ensure the aesthetic panel weight is a minimum of 3kg and a maximum of 6kg. After the aesthetic panel is installed, the tension of the dishwasher door spring can be adjusted by rotating the adjusting bolt. If the tension is right, the door will remain horizontal in the fully open position.
Page 10
installation 13. Adjust the adjustable feet again to obtain the optimum levelling of the unit. screw cone gear level 14. Make sure your plumbing is suitable for water mains use with the dishwasher. If in doubt contact a qualified plumber. This unit MUST BE connected to COLD WATER MAINS using Y-Adaptor the new water inlet hose.
Page 11
installation • You may use the U-shaped drain hose holder to secure your drain hose and to avoid bending it. U-shaped drain water drain hose holder hose • Secure the water drain hose to the waste pipe to avoid it coming off during the washing process.
control panel 3 in 1 intensive normal economy rinse glass rapid delay on/off 1. programme button • press this button to select the washing programme. programme indicator light • illuminates when the selected washing programme is running. salt refill warning light •...
before operating to open the door • Pull the door handle. • If the door is opened during operation all functions are automatically interrupted. to close the door • After loading the dishes, push the baskets fully into the dishwasher. •...
adding detergent power or tablet Only use detergents specifically designed for use in dishwashers. To be more environmentally friendly, please use no more than the correct amount of detergent. Fill the detergent dispenser with detergent powder or tablet. Bleach and Irritant Countertop detergent Keep out of the reach of children...
adding rinse aid Rinse aid helps to ensure water does not cling and leave marks on crockery during the drying phase and helps crockery dry faster after it has been washed. Only pour rinse aid that is for domestic dishwashers into the reservoir. This model is designed to use liquid rinse aids only. Please follow the steps below to pour the rinse aid into the storage reservoir, and the amount will dispense automatically.
adding salt If the water in your area is hard, deposits will form on your dishes and utensils. This appliance contains a salt reservoir for you to reduce the hardness of the water. Please follow the steps below to pour the salt into the salt reservoir and it must be set to correspond to the water hardness level in your area.
Adjusting Salt Consumption Salt consumption must be adjusted to correspond to the water hardness level in your area. If you don’t know how hard the water in your home is, please ask the company that supplies water in your area. It is recommended that adjustments should be made in accordance with the following chart.
loading the dishwasher before loading the dishwasher Please observe the following notes before loading your cutlery and crockery into the basket. • Remove lipstick stains and any food residues from crockery and dishes. Rinse if necessary. • Dishes and cutlery must not lay inside one another, or cover each other. •...
For safety reasons, do not operate the dishwasher without the upper and lower baskets in place. upper basket We recommend using the upper basket for small and lightweight items such as cups saucers, glasses, dessert bowls, etc. Shallow pans or casserole dishes can also be placed in the dishwasher basket.
hinged cup rack To make room for taller items in the upper basket, raise the cup rack upwards. You can then lean the tall glasses against it. You can also remove it when it is not required for use. raise upwards To prevent water dripping from the upper basket onto the dishes in the lower basket, we recommend that you empty the lower basket first and then the upper basket.
loading the lower basket for 12 place settings For loading the lower basket, please refer to the table below. number item dessert dishes oval platter dinner plates soup plates cutlery basket cutlery basket To make unloading much easier, cutlery should be grouped in zones and placed in the cutlery basket.
starting a wash cycle Please follow the steps below to start a wash cycle. 1. Ensure the unit is connected to the mains power and the water supply is on (water pressure between 0.04MPa and 1.00MPa). 2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets back.
switching off the unit To save energy, remember to switch the dishwasher off using the on/off button. The dishwasher will continue to use electricity until it is switched off with the on/off button. If the dishwasher is not going to be used for a long period of time, e.g.
cleaning after use external care the door and the door seal • Clean the door seals regularly with a soft damp cloth to remove food deposits. • When the dishwasher is being loaded, food and drink residues may drip onto the sides of the dishwasher door.
spray arms Particles of food can get stuck in the spray arm jets and bearings. The spray arms should therefore be checked and cleaned regularly. • Ensure the dishwasher is switched off. Use a pointed object, e.g. a cocktail stick, to loosen food particles in the spray arms’...
hints and tips • Repairs should only be carried out by a qualified technician in strict accordance with current local and national safety regulations. Unauthorised or incorrect repairs could cause personal injury or damage to the unit. • Before calling for service, please refer to Helpful Tips to solve some general problems by yourself.
general problems problem possible causes remedy Detergent residue is left in the The detergent dispenser was Make sure the dispenser is dry dispenser at the end of the still damp when detergent was before adding detergent. programme. added. The detergent dispenser lid Clogged detergent residue is Clean the catch.
disposal of the dishwasher • When disposing your old dishwasher, first make it unusable. Disconnect the hoses and unplug the mains cable. Cut off the mains cable from the dishwasher. Make the door lock inoperative, so that children cannot accidentally shut themselves in. Make appropriate arrangements for the disposal of the dishwasher.
KID60S10 dimensions 595 mm (W) x 540 mm (D) x 820 mm (H) capacity 12 place settings water pressure required 0.04 - 1.00MPa power consumption 1930W rated voltage 230V~50Hz Features and specifications are subject to change without prior notice.
safety warnings general use • Switch off and unplug before fitting or removing tools/attachments, after use and before cleaning. • Keep your fingers away from moving parts and fitted attachments. • Never use a damaged machine. • Keep the mains cable out of reach from children. •...
Page 33
• If the mains cable is damaged, it must be replaced by the manufacturer or its service agent in order to avoid a hazard. • Remove the door to the washing compartment when removing an old dishwasher from service or discarding it. •...
Page 36
If you have a query about the product please contact our product support line 0844 561 6263 (Currys). DSG Retail Ltd • Maylands Avenue • Hemel Hempstead • Herts • HP2 7TG • England (P.N.: KID60S10-002) KID60S10_IB_110426.indd 36 4/27/11 5:48 PM...
Need help?
Do you have a question about the KID60S10 and is the answer not in the manual?
Questions and answers